Lemorau MEBR+ Advanced II

1234567

Lemorau MEBR+ Advanced II  330 mm is a modular  printing and finishing machine that was fully customized according to the customer needs. The machine is full servo driven equipped with four smart concept flexo stations in rotary with register. This configuration has available the new automatic positioning of slitting knives and it die cuts in semi-rotary mode at 80m/min.

  • Web width 330 mm
  • Maximum semi-rotary speed 80 m/min (262,5 ft/min.) dependent on plate size
  • Maximum rotary speed 120 m/min (394 ft/min.)
  • Maximum unwinder diameter 700mm, servo driven, with automatic stop at master roll end
  • Splice table with pneumatic clamps
  • Electronic web guide system with ultrasonic sensor which enables guiding of opaque and clear materials
  • 4 smart concept flexo stations, rotary in register with UV+IR curing
  • Turnbar which allows printing on the back
  • 2 die cutting stations in register, semi-rotary and rotary mode with anvil roll with adjustable gap and pressure gauges
  • Speed pack for semi-rotary mode at 80m/min. with magnetic cylinder 190z
  • Waste rewinder
  • Automatic positioning of slitting knives (6 sets)
  • Air trim removal
  • QRC (Quick Remote Assistance)
  • Electronic Counter (Labels/ Meters/ Rolls)
  • Maximum rewinder diameter 600mm, servo driven
  • Deflation software for use of rotary flexible dies on the semi-rotary die cutting
  • Automatic web tension control system by servo motors – Constant and Taper tension
  • 250 Job memory for easy and quick job set ups
  • Paper and matrix break detection
  • Labels in/ labels out rewinding
  • Foot pedal to jog the machine
  • Multi language touch screen